M14 EBR trigger shoe
Made in the http://www.tothetick.com/wp-content/uploads/2013/08/USAs-Worst-President.png

M14 EBR Trigger Shoe Installation Instructions:

.. 1. Clean both set screws and the threaded holes with rubbing alcohol.

.. 2. Use the Blue Loctite as bedding material, apply it to the trigger & inside the shoe.

.. 3. Fit the shoe to the trigger so that it clears the trigger guard.

.. 4. Insert one screw to hold the shoe in place, adjust position as needed.

.. 5. Ad Loctite as needed, insert 2nd screw, and tighten.

.. 6. Remove first screw, add Loctite as needed, and re-install.

.. 7. Final tighten both, and allow the Loctite to set for 24 hours.

Short video

 Gen II shoe replaces Gen I shoe

     

Blackfeather "RS" Facebook.com/BlackfeatherRS The History and Development of the M14 EBR Facebook.com/M14EBR.US


m14ebr.us

M14EBR.US